There are no vlans configured and as far as I am aware no extra config was done on the "working" 2950. However when I connect both switches I have no link light on the ports I've connected (with straightthrough and crossover cable). I'd like to connect both new 2950 switch to the one in the other classroom and have ran cabling to do this. I have set up second class room and put another 2950 switch into it.
This 2950 switch is connected to another switch back in the comms room on port 24, connectivity is fine on this switch. One has a 2950 switch in it where machines in that room are connected.
For more information, see the section titled Clearing the Switch IP Address and Configuration.I think this is the most apt forum but if there is a better one please let me know. If they did, a configuration already exists on the switch and the switch cannot go into Express Setup mode.Did all of the Mode LEDs begin to blink after you have held the Mode button for 2 seconds?.If not, make sure that only the SYST and STAT LEDs are green before pressing the Mode button to begin Express Setup.Did you verify that POST successfully ran before starting Express Setup?.Wait 30 seconds before entering 10.0.0.1 in the browser. If not, reconnect the cable to the Ethernet port on the switch and PC.Did you connect a crossover instead of a straight-through Ethernet cable between an Ethernet port of the switch and the Ethernet port of the PC, as shown Figure 3?.Re-enter 10.0.0.1 in the browser, and press Enter.Did you enter the wrong address in your web browser, or is there an error message displayed in the browser window?.If not, wait 30 seconds and re-enter 10.0.0.1 in the browser, and press Enter.
#How to console into a cisco 2950 switch Pc
Did you wait 30 seconds after connecting the switch and PC or workstation before entering the IP address in your browser?.
See Appendix A: Setting up the IP address on your PC to use Express Setup for help. Did you release and renew the IP address on your PC using DHCP or manually configure its address to 10.0.02?.
#How to console into a cisco 2950 switch software
Connect the other end of the cable to the Ethernet port on the PC and verify that the port status LEDs on both connected Ethernet ports are green.Ħ.Wait approximately 30 seconds after the port LEDs turn green, and launch a web browser on your PC.ħ.If you are using DHCP on your PC, you need to obtain the 10.0.0.2 IP address from the switch now.ĭo one of the two following options depending on the operating system on your PC. Connect the Ethernet cable (not included) to a 10/100 Ethernet port on the front panel of the switch,Ĭaution: Do not connect the switch to any device other than the PC being used to configure it.ĥ. See the section of this document Clearing the Switch IP Address and Configuration for the instructions on deleting a configuration file from a switch.Ĥ. In this case the switch cannot enter Express Setup mode. Note: If all of the Mode LEDs begin to blink after you have held the Mode button for 2 seconds or you cannot get the four LEDs to remain lit, a configuration already exists on the switch. When the four LEDs turn green, release the Mode button. Note: This only works on switches that do not have a configuration file in their file system.ģ. Press and hold the Mode button, as shown in Figure 1, until the four LEDs next to the Mode button turn green. Verify that no devices are connected to the switch.Ģ. Follow these steps to start the Express Setup program.ġ.
0 kommentar(er)
